Features

• Modular Design Allows Stages to be Easily Configured in XY and XYZ Orientations
• Versions Available with Adjuster Screw, Micrometer, or Differential Adjuster
• Wide Range of Compatible Actuators (See Actuators Tab for Details)
• Sixteen 1/4"-20 (M6) Tapped Mounting Holes

The translation stages have a 1" translation and feature hardened steel linear bearings for precision motion and long life. These translation stages are available preconfigured (see note below) with an adjuster screw, standard manual micrometer, or differential adjuster. The actuator on the translation stage can be removed by loosening the screw on the barrel clamp with a 3/32" hex key.

Each stage comes with two precision dowel pins that allow the PT series of translation stages to be stacked in right- or left-handed XY configurations with excellent orthogonality of <5 mrad. The right-handed XYZ configuration, with either the standard manual micromete or the differential micrometer, is available fully assembled below.

It is configured with the 150-811ST micrometer drive, which has a 1" travel range and engraved graduations every 0.001" (10 µm). The PT1/M is fitted with the metric 150-801ST micrometer, which has a 25 mm travel range and engraved graduations every 10 µm. Each stage contains sixteen 1/4"-20 (M6) tapped mounting holes that are 0.22" (5.8 mm) deep. Two 1/4"-20 (M6) counterbores allow the stage to be directly attached to a breadboard or mounting adapter (sold below) with user-supplied cap screws.